Planet Technology VC-412 Bedienungsanleitung

Intelligent Ethernet over VDSL Switch VC-412 User’s Manual

VC-412 User’s Manual 6 2. INSTALLATION 2.1 Connecting VC-412 The VC-412 has the ability to provide u

VC-412 User’s Manual 7 2.2 Console Port Setup

VC-412 User’s Manual 8 The VC-412 contains a powerful management interface accessible through the Co

VC-412 User’s Manual 9 . Once you have assigned a valid IP address to the Switch, proceed to chapter

VC-412 User’s Manual 103. WEB CONFIGURATION 3.1 Web configuration setup Configuration through Web br

VC-412 User’s Manual 11 E. A password dialog will appear prompting for username and password. The

VC-412 User’s Manual 123.2 Monitor Configuration 3.2.1 Unit Information After the correct username a

VC-412 User’s Manual 13 3.2.2.2 TRUNK PORT INFORMATION Under this section you will be able to mon

VC-412 User’s Manual 14settings of the switch such as refresh time (the rate at which the monitoring

VC-412 User’s Manual 153.3.3 Reboot System Reboot System option reboots the VC-412 when it seems to

VC-412 User’s Manual 1 Trademarks Copyright  PLANET Technology Corp. 2002. Contents subject to r

VC-412 User’s Manual 16 3.4.2 SNMP Access Table Under SNMP Access Table and SNMP Trap Receiver Tabl

VC-412 User’s Manual 17 3.4.3 SNMP Trap Receiver Table The SNMP Trap Receiver Table is a set of us

VC-412 User’s Manual 18Note: Be sure to press the Set Value button at the bottom of the screen to ad

VC-412 User’s Manual 194. COMMANDS FOR CONSOLE AND TELNET Once successfully logged into the VC-412,

VC-412 User’s Manual 20 4.2.1 System Configuration Choosing System Configuration will allow you to

VC-412 User’s Manual 21 Figure 24 II. To change password select option 7 and press “Enter” key. T

VC-412 User’s Manual 22 Important: There is only one set of password; therefore the password will

VC-412 User’s Manual 23the VC-412. Note: The password for HTTP is the same as the password in Consol

VC-412 User’s Manual 24Enter key, otherwise press Enter key without entering any information to canc

VC-412 User’s Manual 25 4.3 SNMP Access Table/SNMP Trap Receive Control Table Choosing option 2 in

VC-412 User’s Manual 2 1. INTRODUCTION...

VC-412 User’s Manual 264.4 VDSL Unit Control To monitor and issue commands to the VC-412: Select opt

VC-412 User’s Manual 27 4.4.3 Display All Ports Status of Unit This option displays the statuses of

VC-412 User’s Manual 28The E/S/A/Er Column represents the current operating status of the ports. E-

VC-412 User’s Manual 29 Note: Packet throughput is polled every 6 seconds. 4.5 Reset To Default At t

VC-412 User’s Manual 30 4.7 Logout After finished issuing commands to the VC-412, it is recommended

VC-412 User’s Manual 315. ICD COMMANDS FOR TELNET AND CONSOLE NOTE: DO NOT ATTEMPT TO ISSUE COMMAND

VC-412 User’s Manual 32 The above line indicates “U00-ICD>”. The unit is now ready to be adminis

VC-412 User’s Manual 33VDSL port Enable Speed Mode = Auto Speed X To exit ICD command prompt VLAN C

VC-412 User’s Manual 34P Show the status of all ports. Legend: RS Err = Reed Solomon Error AUT =

VC-412 User’s Manual 35non-communicative to the other ports on the VC-412 in regards to local traffi

VC-412 User’s Manual 3 4.4.2 Set Each VDSL Port Name of Unit ...

VC-412 User’s Manual 36VG 1-1,2,A Add port-4, port-8 and port-D to group 1 from previous example VG

VC-412 User’s Manual 37connected port of the VC-412 to the same speed. The reason you need to set th

VC-412 User’s Manual 38 The “PC” command displays all ports Transmit, Receive and Collision statuse

VC-412 User’s Manual 39APPENDIX A – VC-412 FACTORY DEFAULT Virtual LAN – On Ethernet Speed – 100 F

VC-412 User’s Manual 40 APPENDIX B – UPDATE VC-101S FIRMWARE TO R4.5 REMOTELY THROUGH VC-412 The pur

VC-412 User’s Manual 41can not be saved. Thus, you have to continue the following command to upda

VC-412 User’s Manual 42 For more detailed ICD command description please refer to the Chapter 5.

VC-412 User’s Manual 1 1. INTRODUCTION Thank you for choosing the VC-412 VDSL Managerial Switch fo

VC-412 User’s Manual 2  Back Pressure and IEEE 802.3x compliant flow control  Supports 8K MAC ad

VC-412 User’s Manual 3  Operating Temperature: 32 to 122°F (0 to 50°C)  Storage Temperature: -13

VC-412 User’s Manual 4 1.4 LED Indicators And Button Definition LED Function Color Status Descri

VC-412 User’s Manual 5 Button Function Reset Push to reboot the switch Normal / Uplink Normal: Whe