Planet Technology FGSW-2402PVS Bedienungsanleitung PDF herunterladen (Seite 10)







Note:

When choosing a location, please keep in mind the environmental restrictions discussed in

Chapter 1, Section 4, Specification.

Step4: Connect your Switch to network devices

A. Connect one end of a standard network cable to the 10/100 RJ-45 ports on the front of the Switch.

B. Connect the other end of the cable to the network devices such as printer servers, workstations or

routers…etc.







Note:

Connection to the Switch requires UTP Category 5 network cabling with RJ-

45 tips. For more

information, please see the Cabling Specification in Appendix A.

Step5: Supply power to the Switch.

A. Connect one end of the power cable to the Switch

B. Connect the power plug of the power cable to a standard wall outlet then power on the Switch.

When the Switch receives power, the Power LED should remain solid Green.



To install the Switch in a 19-inch standard rack, follow the instructions described below.

Step1: Place your Switch on a hard flat surface, with the front panel positioned towards your front side.

Step2: Attach a rack-mount bracket to each side of the Switch with supplied screws attached to the package.

Figure 2-4 shows how to attach brackets to one side of the Switch.

Figure 2-4 Attaching the brackets to the Switch

Caution:

You must use the screws supplied with the mounting brackets. Damage caused to the parts

by using incorrect screws would invalidate your warranty.

Step3: Secure the brackets tightly.

Step4: Follow the same steps to attach the second bracket to the opposite side.

Step5: After the brackets are attached to the Switch, use suitable screws to securely attach the brackets to the

rack, as shown in figure 2-5.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 49 50

Keine Kommentare

Planet Technology FGSW-2402PVS Bedienungsanleitung Seite 10