Planet-technology PL-101E Bedienungsanleitung

1 Powerline Communication Powerline to Ethernet Converter – PL-101E USB to Powerline Network Adapter - PL-101U USER’S MANUAL Networking &a

7 Powerline Frequency Band 4.3MHz to 20.9MHz Encryption 56-bit DES with Key configuration software LEDs: Power Powerline: Link, ACT, Col Dimension 1

8 2. Planning your Powerline Network With PLANET PowerLine products, a network can be created using home powerline. Computers can be networked over

9 3. Powerline to Ethernet Converter Installation 1. Plug the other end of the UTP category 5 cable into the computer’s LAN port. 2. Plug the UTP ca

10 4. USB to Powerline Network Adapter Installation 4.1 Connecting USB to Powerline Network Adapter 1. Plug the other end of the USB cable into the

11 2. Select “Search for the best driver for your device. (Recommended)” and click the Next button. 3. Windows will look for new drivers and ask

12 NOTE: Windows 2000 and XP will inform you that there is no digital signature found. Click the Yes button to continue the installation. 4. Wind

13 5. Click the Yes button to restart your computer, or click the No button to restart later.

14 5. Encrypting Your Powerline Network 5.1 Install the PowerPacket Encryption Utility To start installation of all the powerline devices, you will u

15 3. Enter your User Name and Company Name. Select Anyone who uses this computer (all users) to install a shortcut to the security configuration uti

16 5. If you are running the utility of PL-101E, it may show the following window. Click Yes button if PL-101E has connected to your computer and

2 Copyright Copyright (C) 2002 PLANET Technology Corp. All rights reserved. The products and programs described in this User’s Manual are licensed

17 7. You will be asked to restart your computer. After you click Yes button to restart, the entire installation is complete.

185.2 Run the PowerPacket Encryption Utility After installing the PowerPacket encryption utility for your PL-101E/U, your computer desktop will displ

19 3. The security configuration utility will search your powerline network for other PL-101E or PL-101U devices configured with the same network pa

20 4. The security configuration utility will tell you when the PL-101E/U device has been configured with the network password. Click Finish button.

21 6. Troubleshooting  The power LED does not light up after I installed the PL101E/U device? A: Unplug the UTP category 5 from the computer. Unpl

3 Table of Content Chapter 1 Introduction...1 1.1 Powerline to Ethe

1 1. Introduction Powerline communication is revolution in home and small office networking, greatly simplifying the task of installing a high-speed

2 advantage of the router's features. The PL-101E can also be plugged directly into a cable or DSL modem to allow Internet access and data trans

3 LEDs status LED definition Color Description Power Green The power LED will light up when PL-101E is powered on. Col Green The collision LED f

4 HomePlug 1.0 Ports One Powerline Port One 10Base-T RJ-45 port Cabling Type Powerline: Power Cord LAN: UTP Cat 3 or better Speed Powerline: 14Mbps (

5 1.2.1 Features ♦ HomePlug Powerline Alliance Specification 1.0 compliant ♦ One 2-pin power inlet for both powerline network and power supply ♦ Shar

6 LEDs status LED definition Color Description Power Green The power LED will light up when PL-101U is powered on. Col Green The collision LED fla